Nissan Juke Service and Repair Manual : Diagnosis system (BCM) (without intelligent key system)

Description

Air conditioning system performs self-diagnosis, operation check, function diagnosis, and various settings using diagnosis function of each control unit.

Common item : consult-III Function (BCM - COMMON ITEM)


Common item : consult-III Function (BCM - COMMON ITEM)

APPLICATION ITEM

CONSULT-III performs the following functions via CAN communication with BCM.

SYSTEM APPLICATION


SYSTEM APPLICATION

BCM can perform the following functions for each system.

NOTE

:
It can perform the diagnosis modes except the following for all sub system selection items.


• *1: This item is displayed, but is not used.


• *1: This item is displayed, but is not used.

• *2: For models with automatic A/C, this mode is not used.

Air conditioner : consult-III Function (BCM - AIR CONDITIONER) (Manual A/ C 2WD Models)

DATA MONITOR

Display item list

ACTIVE TEST


ACTIVE TEST

ECU diagnosis information


    Diagnosis system (BCM) (with intelligent key system)
    Description Air conditioning system performs self-diagnosis, operation check, function diagnosis, and various settings using diagnosis function of each control unit. Common item : consult-III F ...

    Other materials:

    P1705 TP sensor
    Description Electric throttle control actuator consists of throttle control motor, accelerator pedal position sensor, throttle position sensor etc. The actuator sends a signal to the ECM, and ECM sends the signal to TCM with CAN communication. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATI ...

    PTC heater
    Component Function Check 1.CHECK PTC HEATER OPERATION 1. Start the engine. 2. Operate fan control dial. 3. Operate temperature control dial to full hot position. 4. Check for warm air at discharge air outlet. NOTE: • Engine must be cold. • Battery must be charged. Is the inspection resu ...

    Clutch pedal position switch
    Component Function Check 1.CHECK FOR CLUTCH PEDAL POSITION SWITCH FUNCTION 1. Turn ignition switch ON. 2. Check the voltage between ECM harness connector and ground. Is the inspection result normal? YES >> INSPECTION END. NO >> Proceed to EC-427, "Diagnosis Procedure" ...