Commercial Service Tool

...

Camshaft valve clearance

Valve Clearance CHECKING AND ADJUSTING THE VALVE CLEARANCE 1. Install the tappet. 2. Install the camshaft. 3. Install the camshaft brackets. : 11 N·m (1.1 kg-m, 8 ft-lb) 4. Place the valves of ...

Other materials:

Headlamp washer nozzle and tube
Exploded View 1. Washer tank 2. Headlamp washer tube (tank side) 3. Headlamp washer tube RH 4. Headlamp washer nozzle connector RH 5. Headlamp washer nozzle bracket RH 6. Headlamp washer nozzle RH 7. Headlamp washer nozzle joint 8. Headlamp washer nozzle bracket LH 9. Headlamp washe ...

P183D side G sensor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE W ...

Power supply and ground circuit
Diagnosis Procedure 1.CHECK 4WD CONTROL MODULE POWER SUPPLY (1) 1. Turn the ignition switch OFF. 2. Disconnect 4WD control module harness connector. 3. Check the voltage between 4WD control module harness connector and ground. 4. Turn the ignition switch ON. CAUTION: Never start the engin ...