Nissan Juke Owners Manual : Aluminum alloy wheels
Wash regularly with a sponge dampened in a mild soap solution, especially during winter months in areas where road salt is used. Salt could discolor the wheels if not removed.
CAUTION
Follow the directions below to avoid staining or discoloring the wheels:
• Do not use a cleaner that uses strong acid or alkali contents to clean the wheels.
• Do not apply wheel cleaners to the wheels when they are hot. The wheel temperature should be the same as ambient temperature.
• Rinse the wheel to completely remove the cleaner within 15 minutes after the cleaner is applied.
Wheels
Wash the wheels when washing the vehicle to maintain their appearance.
• Clean the inner side of the wheels when the wheel is changed or the underside
of the vehicle is washed.
• Inspect wheel rim ...
Chrome parts
Clean chrome parts regularly with a nonabrasive chrome polish to maintain the
finish. ...
Other materials:
C1115 wheel sensor
DTC Logic
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
With CONSULT-III.
1. Stat the en ...
P1778 step motor
Description
• The step motor's 4 aspects of ON/OFF change according to the signal from
TCM. As a result, the flow of line
pressure to primary pulley is changed and pulley ratio is controlled.
• This diagnosis item is detected when electrical system is OK, but mechanical
system is NG.
• This ...
Intelligent key battery
Removal and Installation
1. Release the lock knob at the back of the Intelligent Key and remove the
mechanical key.
2. Insert a flat-blade screwdriver (A) wrapped with a cloth into the
slit of the corner and twist it to separate the upper part from the
lower part.
CAUTION:
• Do not touch t ...
