Nissan Juke Service and Repair Manual : Additional service when removing battery negative terminal
Description
When the battery negative terminal is disconnected, the initialization is necessary for normal operation of power window system.
CAUTION:
The following specified operations can not be performed under the
non-initialized condition.
• Auto-up operation
• Anti-pinch function
Work Procedure
1.SYSTEM INITIALIZATION
Perform system initialization. Refer to PWC-16, "Work Procedure".
>> GO TO 2.
2.CHECK ANTI-PINCH FUNCTION
Check anti-pinch function. Refer to PWC-17, "Work Procedure".
>> END
Diagnosis and repair work flow
WorkFlow
DETAILED FLOW
1.OBTAIN INFORMATION ABOUT SYMPTOM
Interview the customer to obtain the malfunction information (conditions and
environment when the malfunction
occurred) as much as possi ...
Additional service when replacing control unit
Description
When the control unit replaced, the initialization in necessary for normal
operation of power window system.
CAUTION:
The following specified operations can not be performed under t ...
Other materials:
B209f cranking request circuit
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC B209F is displayed with DTC U1000, first perform the trouble diagnosis
for DTC U1000. Refer to PCS-
59, "DTC Logic".
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Perform DTC CONFIRMATION PROCEDURE for DTC P1650. Re ...
Primary speed sensor
Exploded View
1. Transaxle assembly
2. O-ring
3. Primary speed sensor
: Always replace after every
disassembly.
: N·m (kg-m, in-lb)
: Genuine NISSAN CVT Fluid NS-2
Removal and Installation
REMOVAL
1. Remove the battery. Refer to PG-124, "Removal and Installation".
2. Remov ...
Unit removal and installation
Transaxle assembly
MR16DDT : Exploded View
1. Transaxle assembly
: Refer to "INSTALLATION" in
TM-84, "MR16DDT : Removal and Installation" for the locations and tightening
torque.
MR16DDT : Removal and Installation
CAUTION:
Never reuse CSC (Concentric Slave Cylinder). ...
