Drive pinion

Exploded View 1. Filler plug 2. Gasket 3. Drain plug 4. Breather tube 5. Clip 6. Breather hose 7. Breather 8. sub-harness clip 9. sub-harness 10. Rear cover 11. Center stem 12. S ...

General Specification

...

Other materials:

Intake sensor
Exploded View Refer to HA-97, "Exploded View (Automatic Air Conditioning)". Removal and Installation REMOVAL 1. Remove evaporator assembly. Refer to HA-115, "EVAPORATOR : Removal and Installation". 2. Remove intake sensor from evaporator. INSTALLATION Note the followin ...

Precautions
Liquid Gasket REMOVAL OF LIQUID GASKET SEALING • After removing mounting nuts and bolts, separate the mating surface using the seal cutter [SST: KV10111100 (J-37228)] (A) and remove old liquid gasket sealing. CAUTION: Be careful not to damage the mating surfaces. • Tap the seal cutter [SS ...

Draining
1. Start engine and let it run to warm up transaxle. 2. Stop engine. Remove drain plug (1) and gasket, using a socket [Commercial service tool] and then drain gear oil. 3. Set a gasket on drain plug and install it to clutch housing, using a socket [Commercial service tool]. CAUTION: Never re ...