Nissan Leaf 2018-2025 (ZE1) Owner's Manual : Flat towing
Flat towing refers to the practice of towing a vehicle with all four wheels in direct contact with the road surface.
This transport method is frequently employed by owners who wish to tow a vehicle behind a recreational vehicle, such as a motor home, while traveling.
CAUTION
- Failure to strictly adhere to these guidelines can result in severe and permanent damage to the reduction gear assembly of your Nissan Leaf.
- DO NOT, under any circumstances, tow this vehicle with all four wheels on the ground (flat towing).
- For authorized emergency towing procedures, please refer to the section titled "Towing your vehicle" in this manual.
NOTE:
In the event that the high-voltage Li-ion battery becomes completely discharged:
- The vehicle system is automatically set to the ON position, yet it will be impossible to transition to the READY mode required to drive the vehicle.
- The transmission is automatically switched into the N (Neutral) position, rendering it impossible to operate or drive the Nissan Leaf.
Vehicle loading information
WARNING
It is extremely dangerous to ride in the cargo area inside the vehicle.
In the event of a collision, individuals positioned in these unsecured areas are significant ...
Uniform tire quality grading
The Department of Transportation (DOT) mandates Quality Grades for all passenger car tires. All tires must conform to stringent federal safety requirements in addition to these comparative performance ...
Other materials:
P0706 transmission range sensor A
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition
switch OFF and wait for at
least 10 seconds, then perform the next test.
>> GO TO 2.
2.PERFORM DTC CONFIRMATION ...
Light & rain sensor
Exploded View
CAUTION:
When the light & rain sensor is removed from windshield, the light & rain sensor
cannot be re-used.
REMOVAL
1. Light & rain sensor bracket
2. Mirror base
3. Light & rain sensor
4. Inside mirror assembly
: Pawl
: Do not reuse
Removal and Installa ...
C1155 brake fluid level switch
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
With CON ...
