Nissan Juke Service and Repair Manual : Commercial Service Tools


System description


    Other materials:

    P181E steering angle sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE With ...

    Component parts
    Component Parts Location LHD 1. ABS actuator and electric unit (control unit) 2. Front wheel sensor 3. Stop lamp switch 4. Rear wheel sensor A. Inside engine room B. Steering knuckle C. Brake pedal D. ABS warning lamp, brake warning lamp (in combination meter) E. Rear wheel hub and ...

    B26F7 BCM
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Press door request switch. 2. Turn ignition switch ON. 3. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III. Is DTC detected? YES >> Go to SEC-127, "Diagnosis P ...