Nissan Juke Owners Manual : Warning and indicator lig



: if so equipped


: if so equipped

    Engine compartment
    MR16DDT ENGINE 1. Engine oil filler cap 2. Radiator filler cap Vehicle overheat 3. Brake and clutch fluid reservoir 4. Air cleaner 5. Window washer fluid reservoir 6. Engine drive bel ...

    Other materials:

    P060B ECM
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.INSPECTION START 1. Turn ignition switch ON. 2. Erase DTC. 3. Turn ignition switch OFF and wait for 20 seconds. 4. Turn ignition switch ON and perform the self-diagnosis. Is the DTC P060B displayed again? YES >> GO TO 2. NO &g ...

    Idle neutral control learning
    Description TCM corrects an individual difference in clutch clearance of the transaxle assembly by performing the idle neutral control learning and enables accurate idle neutral control. Therefore, it is required to perform idle neutral control learning after the following work is performed ...

    Security indicator lamp does not turn on or blink
    Description Security indicator lamp does not blink when ignition switch is in a position other than ON. NOTE: Before performing the diagnosis, check Work Flow. Refer to SEC-47, "Work Flow". Check that vehicle is under the condition shown in CONDITIONS OF VEHICLE (OPERATI ...