Nissan Juke Service and Repair Manual : Service data and specifications (SDS)

Wheel Bearing

Rear Axle 4WD


    Removal and installation
    REAR WHEEL HUB Exploded View 1. Rear suspension beam 2. Rear brake assembly 3. Hub bolt 4. Wheel hub assembly (Bearing-integrated type) 5. Disc rotor 6. Plug : Always replace after every ...

    Other materials:

    Service Notice or Precautions for Manual Transaxle
    CAUTION: Never reuse CSC (Concentric Slave Cylinder). Because CSC slides back to the original position every time when removing transaxle assembly. At this timing, dust on the sliding parts may damage a seal of CSC and may cause clutch fluid leakage. Refer to CL-27, "Removal and Inst ...

    Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
    NOTE: Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. Always use CONS ...

    ECU diagnosis information
    ECM Reference Value TERMINAL LAYOUT PHYSICAL VALUES NOTE: ECM is located in the engine room left side near battery. When disconnecting ECM harness connector (1), loosen (B) it with levers as far as they will go as shown in the figure. 2 : ECM A : Fasten Pulse signal is measured by ...