Nissan Juke Owners Manual : Ignition switch (models without Intelligent Key system)
WARNING
Never remove or turn the key to the LOCK position while driving. This may cause the driver to lose control of the vehicle and could result in serious vehicle damage or personal injury.
Driving safety precautions
Your NISSAN is designed for both normal and off-road use. However, avoid driving in deep water or mud as your NISSAN is mainly designed for leisure use, unlike a conventional off-road vehicle. Re ...Continuously Variable Transmission (CVT)
The ignition lock is designed so that the ignition switch cannot be turned to the LOCK position until the shift lever is moved to the P (Park) position. • When turning the ignition switch to the ...Other materials:
Removal and Installation
REMOVAL
1. Separate the rear propeller shaft. Refer to DLN-121, "Removal and
Installation".
2. Remove right side drive shaft. Refer to FAX-24, "RIGHT SIDE : Removal and
Installation".
3. Remove catalyst convertor support bracket (RH). EM-35, "4WD : Removal and
Insta ...
Air cleaner
To remove the filter, pull the air duct1 upward to remove it. Pull the tabs 2
, then pull the cover3 upward.
The air cleaner filter should not be cleaned and reused. Replace it according
to the maintenance shown in the “NISSAN Service and Maintenance Guide”. When replacing
the filter, wipe ...
P0697 sensor power supply
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.CHECK GROUND CONNECTION
1. Turn ignition switch OFF and wait at least 4 minutes.
2. Check ground connection E38. Refer to Ground Inspection in GI-44, "Circuit
Inspection".
Is the inspection result normal?
YES >> GO TO 2 ...