Nissan Juke Service and Repair Manual : Engine Lubrication System

WITH OIL COOLER

WITHOUT OIL COOLER


WITHOUT OIL COOLER

Engine Lubrication System Schematic


    Engine Lubrication System Schematic
    WITH OIL COOLER WITHOUT OIL COOLER ...

    Other materials:

    Push-button ignition switch illumination circuit
    Description Provides the power supply and the ground to control the push-button ignition switch illumination. Component Function Check 1.CHECK PUSH-BUTTON IGNITION SWITCH ILLUMINATION OPERATION CONSULT-III ACTIVE TEST 1. Turn the ignition switch ON. 2. Select ENGINE SW ILLUMI of BCM (INTEL ...

    B1074, B1075, B1076, B1077, B1078, B1079 diagnosis sensor unit
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform Self Diagnostic Result mode of AIR BAG using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...

    General Precautions
    Always use a 12 volt battery as power source. Do not attempt to disconnect battery cables while engine is running. Before connecting or disconnecting the ECM harness connector, turn ignition switch OFF and disconnect negative battery cable. Failure to do so may damage the ECM because bat ...