Nissan Juke Service and Repair Manual : Yaw rate/side/decel G sensor
Exploded View
1. Yaw rate/side/decel G sensor
2. Yaw rate/side/decel G sensor harness
connector
3. Bracket
: Vehicle front
: N·m (kg-m, in-lb)
Removal and Installation
REMOVAL
CAUTION:
Never drop or strike yaw rate/side/decel G sensor, because it has little
endurance to impact. Never use
a pneumatic tool.
1. Remove front seat (right side).
• 2WD: Refer to SE-19, "Removal and Installation".
• 4WD: Refer to SE-27, "Removal and Installation".
2. Remove floor carpet. Refer to INT-23, "Removal and Installation".
3. Disconnect yaw rate/side/decel G sensor harness connector.
4. Remove yaw rate/side/decel G sensor.
INSTALLATION
Note the following, and install in the reverse order of removal.
• Never drop or strike yaw rate/transverse/decel G sensor, because it has little endurance to impact. Never use a power tool.
ABS actuator and electric unit (control unit)
Exploded View LHD MR16DDT (2WD), HR16DE 1. ABS actuator and electric unit (control unit) 2. ABS actuator and electric unit (control unit) harness connector 3. Bracket A. To front LH caliper ...Steering angle sensor
Removal and Installation REMOVAL 1. Remove spiral cable assembly. Refer to SR-16, "Removal and Installation". 2. Remove steering angle sensor. INSTALLATION Note the following, and i ...Other materials:
Changing wheels and tires
Tire rotation
NISSAN recommends rotating the tires every 5,000 miles (8,000 km). (See “Flat
tire” for tire replacing procedures.)
As soon as possible, tighten the wheel nuts to the specified torque with a
torque wrench.
Wheel nut tightening torque:
80 ft-lb (108 N·m)
The wheel nuts ...
Parking brake control
Exploded View
2WD
1. Parking brake lever assembly
2. Adjusting nut
3. Parking brake switch
4. Front cable
5. Rear cable (LH)
6. Rear cable (RH)
: Apply multi-purpose grease.
: N·m (kg-m, ft-lb)
: N·m (kg-m, in-lb)
: Always replace after every
disassembly.
4WD
1. Parking brake ...
Air cleaner and air duct
Exploded View
1. Turbocharger air inlet pipe
2. Clamp
3. Air duct (suction)
4. Air mass flow sensor
5. O-ring
6. Air duct (inlet)
7. Grommet
8. Air cleaner case
9. Air cleaner filter
10. Cover
11. Holder
A. : To turbocharger
: Vehicle front
: N·m (kg-m, in-lb)
: Always replac ...