Nissan Juke Owners Manual : Window washer fluid

To fill the window washer fluid reservoir, lift the cap and pour the window washer


To fill the window washer fluid reservoir, lift the cap and pour the window washer fluid into the reservoir opening.

Add a washer solvent to the washer for better cleaning. In the winter season, add a windshield washer antifreeze. Follow the manufacturer’s instructions for the mixture ratio.

Fill the window washer fluid reservoir periodically.

Add fluid when the low washer fluid warning light illuminates (if so equipped).

To check the fluid level, use your finger to plug the center hole 1 of the cap/tube assembly, then remove it from the reservoir. If there is no fluid in the tube, add fluid.

Refill the reservoir more frequently when driving conditions require an increased amount of window washer fluid.

Recommended fluid: Genuine NISSAN Windshield Washer Concentrate Cleaner & Antifreeze or equivalent

CAUTION

•  Do not substitute engine anti-freeze coolant for window washer solution.

This may result in damage to the paint.

•  Do not fill the window washer reservoir tank with washer fluid concentrates at full strength. Some methyl alcohol based washer fluid concentrates may permanently stain the grille if spilled while filling the window washer reservoir tank.

• Pre-mix washer fluid concentrates with water to the manufacturer’s recommended levels before pouring the fluid into the window washer reservoir tank. Do not use the window washer reservoir tank to mix the washer fluid concentrate and water.

    Brake and clutch (if so equipped) fluid
    For additional brake and clutch fluid information, see “Capacities and recommended fuel/lubricants”  of this manual. WARNING • Use only new fluid from a sealed container. Old, inferior or con ...

    Battery
    • Keep the battery surface clean and dry. Clean the battery with a solution of baking soda and water. • Make certain the terminal connections are clean and securely tightened. •  If the vehicl ...

    Other materials:

    Transaxle assembly
    Exploded View CASE AND HOUSING 1. Differential side oil seal 2. Clutch housing 3. 2 way connector 4. Oil gutter 5. Air breather inner tube 6. Filler plug 7. Gasket 8. Transaxle case 9. O-ring 10. Rear housing 11. Position switch 12. Dowel pin 13. Magnet 14. Drain plug 15. ...

    Chassis maintenance
    Headlamp aiming adjustment (halogen type - LHD) HEADLAMP AIMING ADJUSTMENT (HALOGEN TYPE - LHD) : Description PREPARATION BEFORE ADJUSTING NOTE: • For details, refer to the regulations in your own country. • Perform aiming if the vehicle front body has been repaired and/or the headlamp assemb ...

    Secondary speed sensor
    Exploded View 1. Transaxle assembly 2. Secondary speed sensor 3. O-ring : Always replace after every disassembly. : N·m (kg-m, in-lb) : Genuine NISSAN CVT Fluid NS-2 Removal and Installation REMOVAL 1. Remove air cleaner case. Refer to EM-26, "Removal and Installation". 2. ...