Nissan Juke Service and Repair Manual : Water outlet
Exploded View
1. Engine coolant temperature sensor
2. O-ring
3. Lock plate
4. Gasket
5. Water outlet and thermostat assembly
6. Air relief plug
7. Clamp
8. Water hose
9. Water pipe
A. To radiator hose upper
B. To EGR cooler hose
C. To heater hose
: N·m (kg-m, ft-lb)
: Always replace after every
disassembly.
Removal and Installation
REMOVAL
1. Remove air cleaner case. Refer to EM-280, "Exploded View".
2. Remove vacuum hose.
3. Remove vacuum pump. Refer to EM-293, "Exploded View".
4. Drain engine coolant. Refer to CO-62, "Draining".
CAUTION:
Perform when engine is cold.
5. Remove radiator upper hose. Refer to CO-66, "Exploded View".
6. Remove water hose.
7. Remove water outlet.
INSTALLATION
Install in the reverse order of removal.
Thermostat
Inspection • Place a thread so that it is caught in the valves of the thermostat. Immerse fully in a container filled with water. Heat while stirring. (The example in the figure shows the therm ...Other materials:
Draining
WARNING:
• Never remove radiator cap when engine is hot. Serious burns may occur from
high-pressure engine
coolant escaping from radiator.
• Wrap a thick cloth around the radiator cap. Slowly turn it a quarter of a turn
to release built-up pressure.
Then turn it all the way.
1. Remove eng ...
P0112, P0113 IAT sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following procedure
before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition swit ...
Engine coolant temperature gauge
The gauge 1 indicates the engine coolant temperature.
The engine coolant temperature is within the normal range when the gauge is within
the zone 2 shown in the illustration.
The engine coolant temperature varies with the outside air temperature and driving
conditions.
CAUTION
If the gauge i ...