Nissan Juke Service and Repair Manual : Water hose
Exploded View
1. Hose clamp
2. Water hose A
3. Water hose B
4. Water hose B
5. Water bypass pipe
6. Hose clamp
7. Heater hose
8. Water hose C
A. Water outlet
B. Heater thermostat
C. Oil warmer
D. Heater core
: N·m (kg-m, in-lb)
Removal and Installation
REMOVAL
WARNING:
Never remove the radiator cap when the engine is hot. Serious burns could occur
from high pressure
coolant escaping from the radiator.
CAUTION:
Perform these steps after the coolant temperature has cooled sufficiently.
1. Remove the hose clamp and pull out the water hose A.
2. Remove the hose clamp and pull out the water hose B.
3. Remove the hose clamp and pull out the water hose C.
4. Pull out the heater hose and remove the water bypass pipe. Refer to CO-52, "Exploded View".
5. Remove the bracket.
INSTALLATION
Note the following, and install in the reverse order of removal.
• To install bracket to the CVT assembly, face the from arrow (A) of the bracket ahead of the vehicle.
• When installing water hose (1) to tube (2), refer to insertion length “A” below.
Insertion length “A” : 27 mm (1.06 in)
• When hose clamp (1) is installed on CVT water hose (2), refer to dimension “A” below.
Dimension“A” : 5 – 7 mm (0.20 – 0.28 in)
• The hose clamp should not come on bulge (B).
Inspection
INSPECTION AFTER INSTALLATION
Start the engine, and check the joints for coolant leakage.
Differential side oil seal
Exploded View 1. Transaxle assembly 2. Differential side oil seal (left side) 3. Differential side oil seal (right side) : Vehicle front : Always replace after every disassembly. : Genuine N ...Fluid cooler system
Exploded View 1. Bracket 2. Bracket 3. Bracket 4. CVT fluid cooler 5. Clamp 6. CVT fluid cooler hose C 7. CVT fluid cooler hose B 8. CVT fluid cooler tube assembly 9. CVT fluid cooler ...Other materials:
Terms
It is important to familiarize yourself with the following terms before loading
your vehicle: • Curb Weight (actual weight of your vehicle) - vehicle weight
including: standard and optional equipment, fluids, emergency tools, and spare tire
assembly. This weight does not include passenge ...
EPS warning lamp does not turn off
Description
EPS warning lamp does not turn OFF several seconds after engine started.
Diagnosis Procedure
1.PERFORM SELF-DIAGNOSIS
With CONSULT-III
1. Turn the ignition switch OFF to ON.
2. Perform “EPS” self-diagnosis.
Is any DTC detected?
YES >> Check the DTC. Refer to STC-14, " ...
MDU branch line circuit
Diagnosis Procedure
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the multi display unit for damage, bend
and loose connection (unit
side and connector side).
Is the inspection result ...