Nissan Juke Service and Repair Manual : Water hose
Exploded View
1. Hose clamp
2. Water hose
A. Water outlet
B. Oil warm
Removal and Installation
REMOVAL
WARNING:
Never remove the radiator cap when the engine is hot. Serious burns could occur
from high pressure
coolant escaping from the radiator.
CAUTION:
Perform these steps after the coolant temperature has cooled sufficiently.
1. Remove the hose clamp and remove the water hose.
INSTALLATION
Note the following, and Install in the reverse order of removal.
CAUTION:
Never reuse copper washer.
• Refer to the following when installing water hoses.
- Insert water hose according to dimension “L” described below.
- Set hose clamps (1) at the both ends of water hoses (2) with dimension “A” from the hose edge.
Dimension “A” : 5 – 7 mm (0.20 – 0.28 in)
- Hose clamp should not interfere with the bulge of fluid cooler tube.
Inspection
INSPECTION AFTER INSTALLATION
Start the engine, and check the joints for coolant leakage. Refer to CO-11, "Inspection".
Oil pump fitting bolt
Description Replace the oil pump fitting bolt and the O-ring if oil leakage or exudes from the oil pump fitting bol Exploded View 1. Oil pump fitting bolt 2. O-ring 3. Transaxle assembly : ...Fluid cooler system
Exploded View 1. Copper washer 2. CVT fluid cooler tube 3. Hose clamp 4. Fluid cooler hose A 5. Fluid cooler tube 6. Fluid cooler hose B 7. Fluid cooler hose C 8. Transaxle assembly 9 ...Other materials:
Body construction
Body Construction (RHD Models)
1. Outer side body
2. Outer front pillar reinforcement
3. Upper inner front pillar
4. Lower dash
5. Hoodledge reinforcement
6. Lower front pillar hinge brace
7. Weld nut
8. Side dash
9. Upper hinge plate
10. Lower hinge plate
11. Inner front pillar ...
On board diagnostic (OBD) system
Description
This is an onboard diagnosis system which records diagnosis information
related to the exhaust gases. It
detects malfunctions related to sensors and actuators. The malfunctions are
indicated by means of the malfunction
indicator lamp (MIL) and are stored as DTC in the ECU memory. ...
The parking brake release warning continues sounding, or
does not sound
Description
• The parking brake warning buzzer sounds continuously during vehicle travel
though the parking brake is
released.
• The parking brake warning buzzer does not sound at all even though driving the
vehicle with the parking
brake applied.
Diagnosis Procedure
1.CHECK PARKING BRAKE ...