Nissan Juke Service and Repair Manual : Washer pump
Exploded View
1. Front washer nozzle LH
2. Front washer nozzle RH
3. Front washer tube LH
4. Front washer tube RH
5. Check valve
6. Front washer tube
7. Joint
8. Washer tank inlet cap
9. Washer tank inlet
10. Washer tank
11. Headlamp washer pump
12. Washer pump
13. Packing
14. Rear washer tube
A : Clip
: Clip
: N·m (kg·m, in-lb
Removal and Installation
REMOVAL
1. Remove fender protector RH (front). Refer to EXT-22, "Removal and Installation".
2. Disconnect washer pump connector.
3. Disconnect front washer tube and rear washer tube.
4. Remove washer pump from the washer tank.
5. Remove packing from washer tank.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
• Check that there is no leakage after installation or replace packing with new
part if it has been damage.
• Never twist the packing when installing the washer pump.
Washer tank
Exploded View 1. Front washer nozzle LH 2. Front washer nozzle RH 3. Front washer tube LH 4. Front washer tube RH 5. Check valve 6. Front washer tube 7. Joint 8. Washer tank inlet cap ...Headlamp washer pump
Exploded View 1. Front washer nozzle LH 2. Front washer nozzle RH 3. Front washer tube LH 4. Front washer tube RH 5. Check valve 6. Front washer tube 7. Joint 8. Washer tank inlet cap ...Other materials:
B1130 side air bag module RH
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp statu ...
Microphone signal circuit
Description
Power is supplied from audio unit to microphone. The microphone transmits the
sound voice to the audio unit.
Diagnosis Procedure
1.CHECK CONTINUITY BETWEEN AUDIO UNIT AND MICROPHONE CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect audio unit connector and microphone connector.
...
Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE:
• Before removing and installing any control units, first turn the ignition
switch to the LOCK position, then disconnect
both battery cables.
• After finishing work, confirm that all control unit connectors are connected
properly, then re-connect both
battery cables.
• Always use CONS ...