Nissan Juke Service and Repair Manual : Washer level switch
Removal and Installation
The washer level switch must be replaced together with the washer tank as an assembly. Refer to WW-67, "Removal and Installation".
Headlamp washer pump
Exploded View 1. Front washer nozzle LH 2. Front washer nozzle RH 3. Front washer tube LH 4. Front washer tube RH 5. Check valve 6. Front washer tube 7. Joint 8. Washer tank inlet cap ...Front washer nozzle and tube
Exploded View LHD models 1. Front washer nozzle LH 2. Front washer nozzle RH 3. Cowl top cover 4. Front washer tube (tank side) 5. Front washer tube RH 6. Front washer tube LH : Vehicle ...Other materials:
C1115 wheel sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
With CONSULT ...
Power supply and ground circuit
Diagnosis Procedure
1.CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) IGNITION POWER
SUPPLY
1. Turn the ignition switch OFF.
2. Disconnect ABS actuator and electric unit (control unit) harness connector.
3. Check voltage between ABS actuator and electric unit (control unit) harness
conne ...
Brake pedal vibration or operation sound occurs
Description
• Brake pedal vibrates and motor sound from ABS actuator and electric unit
(control unit) occurs, when the
engine starts.
• Brake pedal vibrates during braking.
CAUTION:
Vibration may be felt during brake pedal is lightly depressed (just placing a
foot on it) in the following
...