Nissan Juke Service and Repair Manual : Vehicle Recovery (Freeing a Stuck Vehicle)
FRONT
1. Remove the hook cover from the bumper using a remover tool.
2. Securely install the vehicle recovery hook stored with jacking tools.
Check that the hook is properly secured in the stored place after use.
WARNING:
• Stand clear of a stuck vehicle.
• Never spin your tires at high speed. This could cause them to explode and result in serious injury. Parts of your vehicle could also overheat and be damaged.
CAUTION:
• Tow chains or cables must be attached only to the vehicle
recovery hooks or main structural members of the vehicle.
Otherwise, the vehicle body will be damaged.
• Never use the vehicle tie downs to free a vehicle stuck in sand, snow, mud, etc. Never tow the vehicle using the vehicle tie downs or recovery hooks.
• Always pull the cable straight out from the front of the vehicle. Never pull on the hook at an angle.
• Pulling devices should be routed so they do not touch any part of the suspension, steering, brake or cooling systems.
• Pulling devices such as ropes or canvas straps are not recommended for use in vehicle towing or recovery.
REAR
Securely install the vehicle recovery hook stored with jacking tools.
• 2WD
• 4WD
Tow Truck Towing
CAUTION: • All applicable state or Provincial laws and local laws regarding the towing operation must be obeyed. • It is necessary to use proper towing equipment to avoid possible damage to the ...Basic inspection
...Other materials:
Back door trim
Exploded View
1. Back door side finisher RH
2. Rear parcel shelf finisher
3. Back door side finisher LH
4. Back door lower finisher
5. Emergency lid
6. Back door pull handle
: Clip
: Pawl
Back door pull handle : Removal and Installation
REMOVAL
CAUTION:
• When removing, always use ...
Removal and installation
COMBINATION METER
Exploded View
REMOVAL
Refer to IP-12, "Exploded View".
DISASSEMBLY
1. Front cover
2. Unified meter control unit
Removal and Installation
REMOVAL
1. Remove cluster lid A. Refer to IP-13, "Removal and Installation".
2. Remove the mounting screws of ...
Writing unit parameter
Description
Perform writing unit parameter of electric controlled coupling after
replacing 4WD control module, rear final
drive assembly or electric controlled coupling. Refer to DLN-39, "Work
Procedure".
Work Procedure
1.WRITE UNIT PARAMETER
With CONSULT-III
1. Confirm the unit ...