Nissan Juke Service and Repair Manual : Vehicle jerks during
Description
The vehicle jerks when ESP function, TCS function, ABS function, EBD function or brake limited slip differential (BLSD) function operates.
Diagnosis Procedure
1.CHECK SYMPTOM
Check that the vehicle jerks when ESP function, TCS function, ABS function, EBD function or brake limited slip differential (BLSD) function operates.
Is the inspection result normal? YES >> Normal NO >> GO TO 2.
2.PERFORM SELF-DIAGNOSIS
With CONSULT-III.
Perform self-diagnosis for “ABS”.
Is any DTC detected? YES >> Check the DTC. Refer to BRC-142, "DTC Index".
NO >> GO TO 3.
3.CHECK CONNECTOR
With CONSULT-III.
1. Turn the ignition switch OFF.
2. Disconnect ABS actuator and electric unit (control unit) harness connector.
3. Check connector terminal for deformation, disconnection and looseness.
4. Connect harness connector and perform self-diagnosis for “ABS” again.
Is the inspection result normal? YES >> GO TO 4.
NO >> Poor connection of connector terminal. Repair or replace connector terminal.
4.CHECK ECM AND TCM SELF-DIAGNOSIS RESULTS
With CONSULT-III.
Perform self-diagnosis for “ENGINE” and “TRANSMISSION” (for CVT models).
Is any DTC detected? YES >> Check the DTC.
NO >> Replace ABS actuator and electric unit (control unit). Refer to BRC-233, "Removal and Installation".
Brake pedal vibration or operation sound occurs
Description • Brake pedal vibrates and motor sound from ABS actuator and electric unit (control unit) occurs, when the engine starts. • Brake pedal vibrates during braking. CAUTION: Vibration ...Normal operating condition
Description ...Other materials:
Service data and specifications (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
Idle Speed
*: Under the following conditions
• A/C switch: OFF
• Electric load: OFF (Lights, heater fan & rear window defogger)
• Steering wheel: Kept in straight-ahead position
Ignition Timing
*: Under the following conditions
• A/C switch: OFF
...
P182E 4WD solenoid right
DTC Logic
DTC DETECTION LOGIC
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.DTC REPRODUCTION PROCEDURE (1)
With CONSULT-III
1. Turn the ...
Component parts
Body control system
BODY CONTROL SYSTEM : Component Parts Location
RHD MODELS
1. BCM
A. Behind of glove box (Left side)
LHD MODELS
1. BCM
A. Behind of instrument lower panel LH
(Left side)
Power consumption control system
POWER CONSUMPTION CONTROL SYSTEM : Component Parts Location
1 ...