Nissan Juke Service and Repair Manual : Vehicle jerks during
Description
The vehicle jerks when ABS function and EBD function operates.
Diagnosis Procedure
1.CHECK SYMPTOM
Check that the vehicle jerks when ABS function and EBD function operates.
Is the inspection result normal? YES >> Normal
NO >> GO TO 2.
2.PERFORM SELF-DIAGNOSIS
With CONSULT-III.
Perform self-diagnosis for “ABS”.
Is any DTC detected? YES >> Check the DTC. Refer to BRC-31, "DTC Index".
NO >> GO TO 3.
3.CHECK CONNECTOR
With CONSULT-III.
1. Turn the ignition switch OFF.
2. Disconnect ABS actuator and electric unit (control unit) harness connector.
3. Check connector terminal for deformation, disconnection and looseness.
4. Connect harness connector and perform self-diagnosis for “ABS” again.
Is the inspection result normal? YES >> GO TO 4.
NO >> Poor connection of connector terminal. Repair or replace connector terminal.
4.CHECK ECM AND TCM SELF-DIAGNOSIS RESULTS
With CONSULT-III.
Perform self-diagnosis for “ENGINE” and “TRANSMISSION” (for CVT models).
Is any DTC detected? YES >> Check the DTC.
NO >> Replace ABS actuator and electric unit (control unit). Refer to BRC-90, "Removal and Installation".
Brake pedal vibration or operation sound occurs
Description • Brake pedal vibrates and motor sound from ABS actuator and electric unit (control unit) occurs, when the engine starts. • Brake pedal vibrates during braking. CAUTION: Vibration ...Normal operating condition
Description ...Other materials:
ECU diagnosis information
EPS control unit
Reference Value
VALUES ON THE DIAGNOSIS TOOL
CAUTION:
The output signal indicates the EPS control unit calculation data. The normal
values will be displayed
even in the event that the output circuit (harness) is open.
*1: Almost in accordance with the value of “MOTOR SIG”. ...
Outside key antenna
Driver side
DRIVER SIDE : Removal and Installation
REMOVAL
Remove the driver side outside handle. Refer to DLK-176, "OUTSIDE HANDLE :
Removal and Installation".
INSTALLATION
Install in the reverse order of removal.
Passenger side
PASSENGER SIDE : Removal and Installation
REMOVA ...
P0846 transmission fluid pressure SEN/SW B
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
CAUTION:
Be careful of the driving speed.
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition
switch OFF and wait for at
least 10 seconds, then perform the next test.
&g ...