Nissan Juke Service and Repair Manual : USB connector and AUX jack
Removal and Installation
REMOVAL
1. Remove cluster tray. Refer to IP-12, "Exploded View".
2. Push the pawl from the back of cluster tray to remove USB connector and AUX jack.
INSTALLATION
Install in the reverse order of removal.
Rear view camera
Removal and Installation REMOVAL 1. Remove back door lower finisher. Refer to INT-34, "Exploded View". 2. Remove rear view camera screws to remove rear view camera. INSTALLATION Insta ...Antenna feeder
Feeder Layout ...Other materials:
Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE:
• Before removing and installing any control units, first turn the ignition
switch to the LOCK position, then disconnect
both battery cables.
• After finishing work, confirm that all control unit connectors are connected
properly, then re-connect both
battery cables.
• Always use CONS ...
ECU diagnosis information
EPS control unit
Reference Value
VALUES ON THE DIAGNOSIS TOOL
CAUTION:
The output signal indicates the EPS control unit calculation data. The normal
values will be displayed
even in the event that the output circuit (harness) is open.
*1: Almost in accordance with the value of “MOTOR SIG”. ...
Rear seat (4WD)
Exploded View
1. Seatback board RH
2. Headrest
3. Headrest holder (locked)
4. Headrest holder (free)
5. Seatback trim RH
6. Seatback pad RH
7. Seatback lock knob
8. Seatback lock knob finisher
9. Seatback lock assembly RH
10. Seat lock cover RH
11. Bush
12. Side hinge
13. Spac ...