Nissan Juke Service and Repair Manual : Upper link

Exploded View

1. Rear suspension member


1. Rear suspension member 2. Adjusting bolt
3. Upper link
4. Eccentric disk
5. Lower link
6. Suspension arm bracket 7. Suspension arm

: Always replace after every: Vehicle front
disassembly.: Always replace after every
disassembly.

Removal and Installation: N·m (kg-m, ft-lb)


Removal and Installation

REMOVAL

1. Remove tires. WT-7, "Removal and Installation".

2. Remove wheel sensor and sensor harness. Refer to BRC-86, "REAR WHEEL SENSOR : Removal and Installation" (Without ESP), BRC-227, "REAR WHEEL SENSOR : Removal and Installation" (With ESP).

3. Set jack under suspension arm.

CAUTION:
• Never damage the suspension arm with a jack.

• Check the stable condition when using a jack.

4. Remove eccentric disc, adjusting bolt, mounting bolt, and nut, then remove upper link.

5. Perform inspection after removal. Refer to RSU-33, "Inspection".

INSTALLATION

Note the following, and install in the reverse order of removal.

• Perform final tightening of rear suspension member and axle installation position (rubber bushing), under unladen conditions with tires on level ground.

• Never reuse upper link mounting nut.

• Perform inspection after installation. Refer to RSU-33, "Inspection".

Inspection

INSPECTION AFTER REMOVAL

Check upper link and bushing for any deformation, cracks, or damage. Replace it if necessary.

INSPECTION AFTER INSTALLATION

1. Check wheel sensor harness for proper connection. Refer toBRC-85, "REAR WHEEL SENSOR : Exploded View" (Without ESP), BRC-225, "REAR WHEEL SENSOR : Exploded View" (With ESP).

2. Check wheel alignment. Refer to RSU-20, "Inspection".

3. Adjust neutral position of steering angle sensor. Refer to BRC-149, "Work Procedure" (With ESP).

    Lower link
    Exploded View 1. Rear suspension member 2. Adjusting bolt 3. Upper link 4. Eccentric disk 5. Lower link 6. Suspension arm bracket 7. Suspension arm : Vehicle front : Always replace afte ...

    Rear stabilizer
    Exploded View 1. Stabilizer bar 2. Bushing 3. Stabilizer clamp 4. Stabilizer link 5. Lower link 6. Rear suspension member : Vehicle front : Always replace after every disassembly. : N ...

    Other materials:

    Parts Requiring Angle Tightening
    • Use the angle wrench [SST: KV10112100] for the final tightening of the following engine parts: - Camshaft sprocket (INT) bolt - Cylinder head bolts - Main bearing cap bolts - Connecting rod cap bolts - Crankshaft pulley bolt (No the angle wrench is required as bolt flange is provided with ...

    Cooler pipe and hose
    Exploded View 1. A/C unit assembly 2. O-ring 3. High-pressure pipe 4. O-ring 5. Low-pressure flexible hose 6. High-pressure flexible hose 7. O-ring 8. Condenser 9. Compressor : Do not reuse : N·m (kg-m, in-lb) : N·m (kg-m, ft-lb) High-pressure flexible hose : Removal and Installa ...

    B1023 passenger air bag off indicator
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...