Nissan Juke Service and Repair Manual : Unit disassembly and assembly

Unit removal and installation
Engine assembly Exploded View 1. Engine torque rod 2. Engine mounting insulator 3. Engine mounting stay 4. Transaxle mounting stay 5. Engine mounting rear bracket 6. Transaxle torque rod ...

Engine stand setting
Preparing the engine to be on the stand Before the engine is mounted on the engine sub-attachment, the engine's electrical harness must be removed and the engine oil drained. 1. Remove the mult ...

Other materials:

Information display (speed limiter)
Component Function Check 1.CHECK INFORMATION DISPLAY (SPEED LIMITER) FUNCTION 1. Start engine. 2. Press speed limiter MAIN switch. 3. Drive the vehicle at more than 30 km/h (20 MPH). CAUTION: Always drive vehicle at a safe speed. 4. Press SET/− switch. 5. Perform a test drive on a fl ...

Unit disassembly and assembly
Torque converter and converter housing oil seal Exploded View 1. Transaxle assembly 2. Converter housing oil seal 3. Torque converter : Always replace after every disassembly. : Apply CVT Fluid NS-2. Disassembly 1. Remove transaxle assembly. Refer to TM-301, "Removal and Installat ...

P1616 ECM
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION 1. Turn ignition switch ON amd wait 2 seconds or more. 2. Check DTC in “Self Diagnostic Result” mode of “ENGINE” using CONSULT-III. Is DTC detected? YES >> Go to SEC-199, &q ...