Nissan Juke Service and Repair Manual : Unit disassembly and assembly
Removal and Installation
REMOVAL 1. Remove rear propeller shaft assembly. Refer to DLN-121, "Removal and Installation". 2. Remove rear drive shaft. Refer to RAX-17, "Removal and Installation". 3. Disc ...Electric controlled coupling
Exploded View 1. Filler plug 2. Gasket 3. Drain plug 4. Breather tube 5. Clip 6. Breather hose 7. Breather 8. sub-harness clip 9. sub-harness 10. Rear cover 11. Center stem 12. S ...Other materials:
Exhaust manifold
Exploded View
1. Stud bolt
2. Exhaust manifold cover
3. Exhaust manifold
4. Gasket
Engine front
: N·m (kg-m, ft-lb)
: N·m (kg-m, in-lb)
: Always replace after every
disassembly.
Removal and Installation
REMOVAL
1. Drain engine coolant. Refer to CO-11, "Draining".
2. Remo ...
P1652 starter motor system COMM
Description
ECM controls ON/OFF state of the starter relay, according to the engine and
vehicle condition. Models with no
Intelligent Key System transmit a control signal directly to IPDM E/R. On the
other hand, models with the Intelligent
Key System transmit a control signal to IPDM E/R by w ...
A/C switch
Component Function Check
1.CHECK A/C ON SIGNAL
With CONSULT-III
1. Turn ignition switch ON.
2. Select “AIR CONDITIONER” of “BCM” using CONSULT-III.
3. Select “AIR COND SW” in “DATA MONITOR” mode, and check status under the
following condition.
Is the inspection result normal?
YES >> ...