Nissan Juke Service and Repair Manual : U1413 trans ACC input
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.PERFORM ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) SELF-DIAGNOSIS
Using CONSULT-III, check the “self diagnosis result” of “ABS” and repair or replace any malfunctioning parts.
>> Refer to BRC-142, "DTC Index".
U1412 long ACC input
DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.PERFORM ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) SELF-DIAGNOSIS Using CONSULT-III, check the “self diagnosis result” of “ABS” and repair ...Power supply and ground circuit
MULTI DISPLAY UNIT MULTI DISPLAY UNIT : Diagnosis Procedure 1.CHECK FUSES Check if any of the following fuses are blown: Is the check result normal? YES >> GO TO 2. NO >> Replace ...Other materials:
LAN System can system (type 4)
DTC/CIRCUIT DIAGNOSIS
Main line between IPDM-E and DLC circuit
Diagnosis Procedure
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose
connection (connector s ...
P0520 EOP sensor
DTC Logic
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following procedure
before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignitio ...
Removal and Disassembly
• When instructed to use SST, use specified tools. Always be careful to work
safely, avoid forceful or uninstructed
operations.
• Exercise maximum care to avoid damage to mating or sliding surfaces.
• Dowel pins are used for several parts alignment. When replacing and
reassembling parts with ...