Nissan Juke Service and Repair Manual : U1010 control unit (can)
Description
Initial diagnosis of multi display unit
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.REPLACE THE MULTI DISPLAY UNIT
If DTC U1010 is detected, replace the multi display unit. AV-125, "Removal and Installation".
>> INSPECTION END
U1000 can comm circuit
Description CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-board multiplex communication line with high data communication speed and excellent ...U1402 engine speed signal
DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.PERFORM ECM SELF DIAGNOSIS Using CONSULT-III, check the “self diagnosis result” of “ENGINE” and repair or replace any malfunctioning parts. ...Other materials:
Symptom diagnosis
Squeak and rattle trouble diagnoses
Work Flow
CUSTOMER INTERVIEW
Interview the customer if possible, to determine the conditions that exist
when the noise occurs. Use the Diagnostic
Worksheet during the interview to document the facts and conditions when the
noise occurs and any of
the cu ...
Door lock operation warning does not operate
Diagnosis Procedure
1.CHECK DOOR LOCK FUNCTION
Check door lock function.
Does door lock/unlock using door request switch?
YES >> GO TO 2.
NO >> Refer to DLK-85, "Component Function Check".
2.CHECK INTELLIGENT KEY WARNING BUZZER
Check Intelligent Key warning buzzer. ...
Vehicle Dynamic Control (VDC) off switch
The vehicle should be driven with the Vehicle Dynamic Control (VDC) system on
for most driving conditions.
If the vehicle is stuck in mud or snow, the VDC system reduces the engine output
to reduce wheel spin. The engine speed will be reduced even if the accelerator is
depressed to the floo ...