Nissan Juke Service and Repair Manual : U1010 control unit (can)

DTC Logic

DTC DETECTION LOGIC

Diagnosis Procedure


Diagnosis Procedure

1.REPLACE BCM

When DTC “U1010” is detected, replace BCM.

>> Replace BCM. Refer to BCS-161, "Removal and Installation".

    U1000 can comm
    Description CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-vehicle multiplex communication line with high data communication speed and excelle ...

    Power supply and ground circuit
    Diagnosis Procedure 1.CHECK FUSES AND FUSIBLE LINK Check that the following fuses and fusible link are not fusing. Is the fuse fusing? YES >> Replace the blown fuse or fusible link after r ...

    Other materials:

    Assembly and Installation
    • Use torque wrench to tighten bolts or nuts to specification. • When tightening nuts and bolts, as a basic rule, equally tighten in several different steps starting with the ones in center, then ones on inside and outside diagonally in this order. If the order of tightening is specified, do ...

    Engine maintenance (MR16DDT)
    Drive belt DRIVE BELT : Exploded View 1. Alternator 2. Drive belt auto-tensioner 3. Crankshaft pulley 4. A/C compressor 5. Water pump 6. Drive belt A. Possible use range B. Range when new drive belt is installed C. Indicator DRIVE BELT : Checking WARNING: Perform this step when ...

    System
    EPS system : System Description • EPS control unit performs an arithmetical operation on data, such as steering wheel turning force (sensor signal) from the torque sensor, vehicle speed signal, etc. Then it generates an optimum assist torque signal to the EPS motor according to the driving condi ...