Nissan Juke Service and Repair Manual : U1001 Can comm circuit

Description

CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN H line, CAN L line) allowing a high rate of information transmission with less wiring.

Each control unit transmits/receives data but selectively reads required data only.

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON and wait at least 3 seconds.

2. Check 1st trip DTC.

Is 1st trip DTC detected? YES >> Proceed to EC-161, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

Perform the trouble diagnosis for CAN communication system. Refer to LAN-17, "Trouble Diagnosis Flow Chart".

    U0122 Vehicle dynamics control module
    Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excelle ...

    P0011 IVT control
    DTC Logic DTC DETECTION LOGIC NOTE: If DTC P0011 is displayed with DTC P0075, first perform the trouble diagnosis for EC-307, "DTC Logic". DTC CONFIRMATION PROCEDURE 1.PRECONDITIONI ...

    Other materials:

    Rear combination lamp
    Exploded View REMOVAL 1. Grommet 2. Grommet 3. Rear combination lamp : Clip : N·m (kg-m, in-lb) DISASSEMBLY 1. Rear combination lamp housing assembly 2. Back-up lamp bulb 3. Harness connector 4. Rear turn signall lamp bulb 5. Stop/tail lamp bulb Removal and Installation CAUTIO ...

    All defogger system dose not operate
    Description Rear window defogger and door mirror defogger do not operate when rear window defogger switch operated. Diagnosis Procedure 1.CHECK REAR WINDOW DEFOGGER SWITCH Check rear window defogger switch. Refer to DEF-26, "WITH AUTO A/C : Component Function Check" (With Auto A/C ...

    Both side front fog lamps are not turned on
    Description The front fog lamps are not turned ON in any condition. Diagnosis Procedure 1.CHECK FUSE Check that the following fuse is fusing. Is the inspection result normal? YES >> GO TO 2. NO >> Repair the applicable circuit. And then replace the fuse. 2.COMBINATION SWITC ...