Nissan Juke Service and Repair Manual : U1000 can comm circuit

Description

CAN (Controller Area Network) is a serial communication system for real time application. It is an on-vehicle multiplex communication system with high data communication speed and excellent error detectability. Many electronic control units are equipped onto vehicles, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with two communication lines (CAN-H line, CAN-L line) allowing a high rate of information transmission with less wiring. Each control unit transmits/receives data but selectively reads required data only.

CAN Communication Signal Chart. Refer to LAN-31, "CAN COMMUNICATION SYSTEM : CAN Communication Signal Chart"

DTC Logic

DTC DETECTION LOGIC

Diagnosis Procedure


Diagnosis Procedure

1.PERFORM SELF DIAGNOSTIC

1. Turn ignition switch ON and wait for 2 seconds or more.

2. Check “Self Diagnostic Result” of “METER/M&A”.

Is “CAN COMM CIRCUIT” displayed? YES >> Refer to LAN-17, "Trouble Diagnosis Flow Chart".

NO >> Refer to GI-42, "Intermittent Incident".

    U1010 control unit (can)
    Description Initial diagnosis of combination meter. DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.REPLACE COMBINATION METER When DTC “U1010” is detected, replace combination meter. &g ...

    Other materials:

    B2193 chain of ECM-IMMU
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2193 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-153, "DTC Logic". • If DTC B2193 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to BCS-154, " ...

    Periodic maintenance
    Periodic Maintenance The following tables show the normal maintenance schedule. Depending upon weather and atmospheric conditions, varying road surfaces, individual driving habits and vehicle usage, additional or more frequent maintenance may be required. Periodic maintenance beyond the la ...

    Three-way catalyst
    The three-way catalyst is an emission control device installed in the exhaust system. Exhaust gases in the three-way catalyst are burned at high temperatures to help reduce pollutants. WARNING • The exhaust gas and the exhaust system are very hot. Keep people, animals or flammable materials ...