Nissan Juke Service and Repair Manual : U1000 can comm circuit

Description

CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-board multiplex communication line with high data communication speed and excellent error detection ability. A modern vehicle is equipped with many ECMs, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, 2 control units are connected with 2 communication lines (CAN-L line and CAN-H line) allowing a high rate of information transmission with less wiring.

Each control unit transmits/receives data but selectively reads required data only.

Refer to LAN-31, "CAN COMMUNICATION SYSTEM : CAN Communication Signal Chart" for details of the communication signal.

DTC Logi

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON and wait at least 2 seconds or more.With CONSULT-III


1. Turn ignition switch ON and wait at least 2 seconds or more.

2. Select “Self Diagnostic Result” mode of “HVAC” using CONSULT-III.

3. Check DTC.

Is DTC detected? YES >> Refer to HAC-51, "Diagnosis Procedure".

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

Diagnosis Procedure

1.CHECK CAN COMMUNICATION SYSTEM

Check CAN communication system. Refer to LAN-17, "Trouble Diagnosis Flow Chart".

>> INSPECTION END

    U1010 control unit (CAN)
    Description Initial diagnosis of A/C auto amp. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE With CONSULT-III 1. Turn ignition switch ON. 2. S ...

    Other materials:

    Symptom diagnosis
    CVT CONTROL SYSTEM Symptom Table The diagnosis item number indicates the order of check. Start checking in the order from 1. ...

    Center console assembly
    Exploded View CVT models 1. Console indicator finisher 2. Instrument lower cover RH 3. Center console assembly 4. Instrument lower cover LH 5. Instrument stay 6. CVT shift selector assembly 7. Console rear bracket 8. Console rear finisher 9. Seat heated switch 10. Console switch f ...

    ECU diagnosis information
    ABS actuator and electric unit (control unit) Reference Value CONSULT-III DATA MONITOR STANDARD VALUE *1: Confirm tire pressure is standard value. *2: Refer to “valve operation” in BRC-105, "System Description" for valve operation of each valve. *3: Refer to BRC-105, "Sys ...