Nissan Juke Service and Repair Manual : U1000 can comm circuit

Description

CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Modern vehicle is equipped with many electronic control unit, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN H-line, CAN L-line) allowing a high rate of information transmission with less wiring. Each control unit transmits/receives data but selectively reads required data only.

CAN Communication Signal Chart. Refer to LAN-31, "CAN COMMUNICATION SYSTEM : CAN Communication Signal Chart".

DTC Logic

DTC DETECTION LOGIC

Diagnosis Procedure


Diagnosis Procedure

1.PERFORM SELF DIAGNOSTIC

1. Turn ignition switch ON and wait for 2 seconds or more.

2. Check “SELF-DIAG [CAN]” in “special function” of “AIR BAG” using CONSULT-III.

Is DTC “U1000” displayed? YES >> Refer to LAN-17, "Trouble Diagnosis Flow Chart".

NO >> Refer to GI-42, "Intermittent Incident".

    U1010 control unit (can)
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.REPLACE AIR BAG DIAGNOSIS SENSOR UNIT When DTC “U1010” is detected, replace Air bag diagnosis sensor unit. >> Replace Air bag diagnos ...

    Other materials:

    Precaution
    Precautions for Suspension • When installing rubber bushings, the final tightening must be carried out under unladen conditions with tires on ground. Spilled oil might shorten the life of rubber bushings. Be sure to wipe off any spilled oil. - Unladen conditions mean that fuel, engine coolant ...

    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
    The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. Information necessary to service the system safely is include ...

    G sensor
    Exploded View 1. G sensor : Vehicle front : N·m (kg-m, in-lb) Removal and Installation CAUTION: • Never drop or strike G sensor, because it has little tolerance for impact. • Never use a power tool to avoid impact. REMOVAL 1. Disconnect the battery cable from the negative terminal. Refer ...