Nissan Juke Service and Repair Manual : U1000 can comm circuit

Description

CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN-H line, CAN-L line) allowing a high rate of information transmission with less wiring.

Each control unit communicate data but selectively reads required data only.

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

>> GO TO 2.

2.DTC REPRODUCTION PROCEDURE

1. Turn the ignition switch OFF to ON.With CONSULT-III


1. Turn the ignition switch OFF to ON.

2. Perform “EPS” self-diagnosis.

Is DTC “U1000” detected? YES >> Proceed to diagnosis procedure. Refer to STC-25, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

Proceed to LAN-17, "Trouble Diagnosis Flow Chart".

    C1609 vehicle speed signal
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 ...

    EPS warning lamp
    Component Function Check 1.CHECK THE ILLUMINATION OF THE EPS WARNING LAMP Check that the EPS warning lamp turns ON when ignition switch turns ON. Then, EPS warning lamp turns OFF after the engine ...

    Other materials:

    System
    AUTO RETRACTABLE DOOR MIRORR FUNCTION AUTO RETRACTABLE DOOR MIRORR FUNCTION : System Diagram AUTO RETRACTABLE DOOR MIRORR FUNCTION : System Description BCM retracts door mirror when door lock signal is received from Intelligent Key or door request switch. OPERATION CONDITION The system oper ...

    P0544 EGT sensor 1
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK GROUND CONNECTIONS 1. Turn ignition switch OFF. 2. Check ground connection E38. Refer to Ground inspection in GI-44, "Circuit Inspection". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or ...

    Removal and Installation
    REMOVAL 1. Remove engine assembly. Refer to EM-55, "2WD : Exploded View" (2WD) , EM-59, "4WD : Exploded View" (4WD). 2. Remove oil pan (lower). Refer to EM-41, "Removal and Installation". 3. Remove front cover, and other related parts. Refer to EM-67, "Explod ...