Nissan Juke Service and Repair Manual : U0300 can communication data

Description

CAN (Controller Area Network) is a serial communication line for real-time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent malfunction detection ability.

Many electronic control units are equipped onto a vehicle, and each control unit shares information and links with other control units during operation (not independently). In CAN communication, control units are connected with 2 communication lines (CAN-H line, CAN-L line) allowing a high rate of information transmission with less wiring. Each control unit transmits/receives data but selectively reads required data only.

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PREPARATION BEFORE WORK

If another “DTC CONFIRMATION PROCEDURE” occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.CHECK DTC DETECTION

1. Start the engine and wait for 5 seconds or more.With CONSULT-III


1. Start the engine and wait for 5 seconds or more.

2. Check the DTC.

Is “U0300” detected? YES >> Go to TM-389, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CONTROL UNIT CHECK

Check the number of control units replaced before “U0300” is detected.

Is one control unit replaced? YES >> The specification of the control unit replaced may be incorrect. Check the part number and the specification.

NO >> GO TO 2.

2.CONTROL UNIT CHECK

1. Remove one of the control unit replaced.With CONSULT-III


1. Remove one of the control unit replaced.

2. Assemble the old control unit before replacement.

3. Turn ignition switch ON, and wait for 2 seconds or more.

4. Select “Self Diagnostic Results” in “TRANSMISSION”.

Is “U0300”detected? YES >> Turn OFF the ignition switch and check other control units in the same manner.

NO >> The specification of the control unit removed may be incorrect. Check the part number and the specification.

    U0155 lost communication (IPC)
    Description CAN (Controller Area Network) is a serial communication line for real-time application. It is an on-vehicle multiplex communication line with high data communication speed and excellen ...

    U1000 can comm circuit
    Description CAN (Controller Area Network) is a serial communication line for real-time application. It is an on-vehicle multiplex communication line with high data communication speed and excellen ...

    Other materials:

    Back door does not opened
    Diagnosis Procedure 1.CHECK BACK DOOR OPENER SWITCH Check back door opener switch. Refer to DLK-244, "Component Function Check". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace the malfunctioning parts. 2.CHECK BACK DOOR OPENER ACTUATOR ...

    Camshaft valve clearance
    Valve Clearance CHECKING AND ADJUSTING THE VALVE CLEARANCE 1. Install the tappet. 2. Install the camshaft. 3. Install the camshaft brackets. : 11 N·m (1.1 kg-m, 8 ft-lb) 4. Place the valves of the cylinder concerned at the “end of exhaust - beginning of inlet” position and check the clearance ...

    Information display (ASCD)
    Component Function Check 1.CHECK INFORMATION DISPLAY 1. Start engine. 2. Press ASCD MAIN switch on ASCD steering switch. 3. Drive the vehicle at more than 40 km/h (25 MPH). CAUTION: Always drive vehicle at a safe speed. 4. Press SET/− switch. 5. Check that the reading of the speedome ...