Nissan Juke Service and Repair Manual : U0073 communication bus A off

Description

CAN (Controller Area Network) is a serial communication line for real-time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent malfunction detection ability.

Many electronic control units are equipped onto a vehicle, and each control unit shares information and links with other control units during operation (not independently). In CAN communication, control units are connected with 2 communication lines (CAN-H line, CAN-L line) allowing a high rate of information transmission with less wiring. Each control unit transmits/receives data but selectively reads required data only.

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PREPARATION BEFORE WORK

If another “DTC CONFIRMATION PROCEDURE” occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE

1. Start the engine and wait for at least 5 seconds.With CONSULT-III


1. Start the engine and wait for at least 5 seconds.

2. Check the DTC.

Is “U0073” detected? YES >> Go to TM-384, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

For the diagnosis procedure, refer to LAN-17, "Trouble Diagnosis Flow Chart".

    U0100 lost communication (ECM A)
    Description CAN (Controller Area Network) is a serial communication line for real-time application. It is an on-vehicle multiplex communication line with high data communication speed and excellen ...

    Other materials:

    Exhaust gas (carbon monoxide)
    WARNING • Do not breathe exhaust gases; they contain colorless and odorless carbon monoxide. Carbon monoxide is dangerous. It can cause unconsciousness or death. • If you suspect that exhaust fumes are entering the vehicle, drive with all windows fully open, and have the vehicle inspected imme ...

    Front coil spring and strut
    Exploded View 2WD 1. Piston rod lock nut 2. Mounting insulator 3. Mounting bearing 4. Bound bumper 5. Coil spring 6. Lower rubber seat 7. Strut 8. Steering knuckle : N·m (kg-m, ft-lb) : Always replace after every disassembly 4WD 1. Piston rod lock nut 2. Mounting insulator ...

    Diagnosis and repair work flow
    Work Flow OVERALL SEQUENCE DETAILED FLOW 1.GET INFORMATION ABOUT SYMPTOM Get the detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurred). >> GO TO 2. 2.CHECK DTC 1. Check DTC for “ENGINE” and “BCM” usin ...