Nissan Juke Service and Repair Manual : Tweeter
Removal and Installation
REMOVAL
1. Remove front pillar garnish. Refer to INT-18, "Exploded View".
2. Remove tweeter clip, then disconnect tweeter connector and remove tweeter.
INSTALLATION
Install in the reverse order of removal.
Front door speaker
Removal and Installation REMOVAL 1. Remove front door finisher. Refer to INT-13, "Exploded View". 2. Remove front door speaker screws, then disconnect front door speaker connector and ...Rear door speaker
Removal and Installation REMOVAL 1. Remove rear door finisher. Refer to INT-16, "Exploded View". 2. Remove rear door speaker screws, then disconnect rear door speaker connector and remo ...Other materials:
Trip computer
The switch for the trip computer is located on the meter panel.
When the ignition switch is placed in the ON position, modes of the trip computer
can be selected by pushing the trip computer mode switchA .
Each time the trip computer mode switchA is pushed, the display will change as
follows ...
A/C auto AMP. Connection recognition signal circuit
Diagnosis Procedure
1.CHECK A/C AUTO AMP. CONNECTION RECOGNITION SIGNAL
1. Turn ignition switch ON.
2. Check voltage between combination meter harness connector and ground.
Is the inspection result normal?
YES >> INSPECTION END
NO >> GO TO 2.
2.CHECK A/C AUTO AMP. CONNECTION R ...
Inspection
INSPECTION AFTER INSTALLATION
• Check accelerator pedal moves smoothly within the whole operation range
when it is fully depressed and
released.
• Check accelerator pedal securely returns to the fully released position.
• For the electrical inspection of accelerator pedal position sensor. Refe ...