Nissan Juke Service and Repair Manual : Transmission range switch
Exploded View
1. Transmission range switch 2. Transaxle assem
Removal and Installation
REMOVAL
1. Remove battery. Refer to PG-124, "Removal and Installation".
2. Remove transmission range switch connector.
3. Remove control cable. Refer to TM-273, "Removal and Installation".
4. Remove transmission range switch from transaxle assembly.
INSTALLATION
Install in the reverse order of removal.
Inspection and Adjustment
ADJUSTMENT OF TRANSMISSION RANGE SWITCH
1. Move selector lever to “N” position.
2. Remove control cable from manual lever.
3. Loosen mounting bolts (A) of transmission range switch. Insert a pin (φ4 mm) into the adjusting holes (B) on both transmission range switch and manual lever for adjusting the position.
4. Tighten mounting bolts of transmission range switch.
5. Connect control cable on manual lever. Refer to TM-194, "Inspection and Adjustment".
ADJUSTMENT AFTER INSTALLATION
Adjust the CVT positions after installing the CVT shift selector. Refer to TM-194, "Inspection and Adjustment".
INSPECTION AFTER INSTALLAION
Check the CVT positions after adjusting the CVT positions. Refer to TM-194, "Inspection and Adjustment".
Key interlock cable
Exploded View 1. CVT shift selector assembly 2. Key interlock cable A: Key cylinder B: Clip C: Clip Removal and Installation REMOVAL CAUTION: Always apply the parking brake before perfor ...TCM
Exploded View 1. Bracket 2. TCM :Vehicle front : N·m (kg-m, in-lb) Removal and Installation NOTE: When replacing TCM and transaxle assembly as a set, replace transaxle assembly first and t ...Other materials:
Maintenance precautions
When performing any inspection or maintenance work on your vehicle, always take
care to prevent serious accidental injury to yourself or damage to the vehicle.
The following are general precautions which should be closely observed.
WARNING
• Park the vehicle on a level surface, apply the ...
System (power door lock system)
System Diagram
System Description
DOOR LOCK FUNCTION
Door Lock and Unlock Switch
• The door lock and unlock switch (driver side) is build into power window main
switch.
• The door lock and unlock switch (passenger side) is build into front power
window switch (passenger side).
• Interloc ...
Fuel injector
Component Function Check
1.INSPECTION START
Turn ignition switch to START.
Is any cylinder ignited?
YES >> GO TO 2.
NO >> Proceed to EC-400, "Diagnosis Procedure".
2.CHECK FUEL INJECTOR FUNCTION
With CONSULT-III
1. Start engine.
2. Perform “POWER BALANCE” in “ACT ...