Nissan Juke Owners Manual : Towing your vehicle

When towing your vehicle, all State (Provincial in Canada) and local regulations for towing must be followed. Incorrect towing equipment could damage your vehicle. Towing instructions are available from a NISSAN dealer. Local service operators are familiar with the applicable laws and procedures for towing. To assure proper towing and to prevent accidental damage to your vehicle, NISSAN recommends that you have a service operator tow your vehicle. It is advisable to have the service operator carefully read the following precautions.

WARNING

• Never ride in a vehicle that is being towed.

• Never get under your vehicle after it has been lifted by a tow truck.

CAUTION

• When towing, make sure that the transmission, axles, steering system and powertrain are in working condition.

If any unit is damaged, dollies must be used.

• Always attach safety chains before towing.

For information about towing your vehicle behind a recreational vehicle (RV), see “Flat towing”  of this manual.

If your vehicle overheats
CAUTION • Do not continue to drive if your vehicle overheats. Doing so could cause engine damage or a vehicle fire. • To avoid the danger of being scalded, never remove the radiator cap while the ...

Towing recommended by NISSAN
Two-Wheel Drive (2WD) models NISSAN recommends that your vehicle be towed with the driving (front) wheels off the ground or place the vehicle on a flat bed truck as illustrated. CAUTION •  ...

Other materials:

RearView monitor (if so equipped)
When the shift lever is shifted into the R (Reverse) position, the monitor display shows the view to the rear of the vehicle. The system is designed as an aid to the driver in situations such as slot parking or parallel parking. WARNING Failure to follow the warnings and instructions for prop ...

B2013 steering lock unit
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Lock the steering. NOTE: 3. Press the push-button ignition switch. 4. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III. Is DTC detected? YES >> Go to SEC-69, & ...

Diagnosis system (BCM)
Common item : consult-III Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the following functions for each system. NOTE: It can perform the diagnosis modes except the following for ...