Nissan Juke Service and Repair Manual : Throttle valve closed position learning
Description
Throttle Valve Closed Position Learning is an operation to learn the fully closed position of the throttle valve by monitoring the throttle position sensor output signal. It must be performed each time harness connector of electric throttle control actuator or ECM is disconnected.
• Electric throttle control actuator is removed.
• Electric throttle control actuator is replaced.
• ECM is replaced.
NOTE
:
The necessary operation is different depending on the operation result of ECM
data save or write. Always
perform the operation according to procedures. Refer to EC-882, "Work
Procedure".
Work Procedure
1.START
1. Make sure that accelerator pedal is fully released.
2. Turn ignition switch ON and wait at least 15 seconds.
Make sure that throttle valve moves during the above 15 seconds by confirming the operating sound.
3. Turn ignition switch OFF and wait at least 4 minutes.
4. Turn ignition switch ON.
>> END
EGR volume control valve closed position learning
Description EGR Volume Control Valve Closed Position Learning is an operation to learn the fully closed position of the EGR volume control valve by monitoring the EGR volume control valve control ...Service regeneration
Description Service Regeneration is performed with CONSULT-III to reduce particulate matter in diesel particulate filter. Service Regeneration should be performed in the following cases. • ECM ...Other materials:
B1081 seat belt Pre-tensioner RH
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp statu ...
Component parts
Component Parts Location
1. Remote keyless entry receiver
Refer to DLK-21,
"Component Parts Location" (With
super lock) or DLK-198,
"Component Parts Location" (Without
super lock).
2. Combination meter
Refer to MWI-4, "METER SYSTEM :
Component Parts Location" ...
In-cabin microfilter
The air conditioning system is equipped with an in-cabin microfilter which collects
dirt, pollen, dust, etc. To make sure the air conditioner heats, defogs, and ventilates
efficiently, replace the filter according to the specified maintenance log shown
in the NISSAN Service and Maintenance Gui ...