Nissan Juke Service and Repair Manual : Thermostat
Inspection
• Place a thread so that it is caught in the valves of the thermostat.
Immerse fully in a container filled with water. Heat while stirring.
(The example in the figure shows the thermostat.) • The valve opening temperature is the temperature at which the valve opens and falls from the thread.
• Continue heating. Check the full-open lift amount.
• After checking the full-open lift amount, lower the water temperature and check the valve closing temperature.
• If the measured value is out of the standard value or unusual valve seating condition is found, replace water inlet and thermostat assembly.
Thermo plunger unit
Exploded View 1. Side member LH 2. Thermo plunger control unit 3. Thermo plunger relay 4. Thermo plunger connector 5. Earth lead 6. Thermo plunger unit 7. Bracket stay Vehicle front : ...Water outlet
Exploded View 1. Engine coolant temperature sensor 2. O-ring 3. Lock plate 4. Gasket 5. Water outlet and thermostat assembly 6. Air relief plug 7. Clamp 8. Water hose 9. Water pipe A ...Other materials:
Refrigerant pressure sensor
Component Function Check
1.CHECK REFRIGERANT PRESSURE SENSOR OVERALL FUNCTION
1. Start engine and warm it up to normal operating temperature.
2. Turn A/C switch and blower fan switch ON.
3. Check the voltage between ECM harness connector and ground.
Is the inspection result normal?
YES >& ...
C1109 power and ground system
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
With CONSULT ...
Component parts
Component Parts Location
1. Combination meter
2. Intelligent Key warning buzzer
3. Push-button ignition switch
4. Inside key antenna (instrument center)
5. TCM
Refer to TM-133, "CVT CONTROL
SYSTEM : TCM" (RE0F10B models)
or TM-316, "CVT CONTROL SYSTEM
: TCM" (RE0F11 ...