Nissan Juke Service and Repair Manual : The parking brake release warning continues sounding, or does not sound
Description
• The parking brake warning buzzer sounds continuously during vehicle travel though the parking brake is released.
• The parking brake warning buzzer does not sound at all even though driving the vehicle with the parking brake applied.
Diagnosis Procedure
1.CHECK PARKING BRAKE WARNING LAMP
1. Start the engine.
2. Check the operation of the brake warning lamp by operating the parking brake.
When parking brake is applied : ON When parking brake is released : OFF
Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-69, "Removal and Installation" NO >> GO TO 2.
2.CHECK PARKING BRAKE SWITCH SIGNAL CIRCUIT
Perform check for the parking brake switch signal circuit. Refer to WCS-41, "Diagnosis Procedure".
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair harness or connector.
3.CHECK PARKING BRAKE SWITCH
Perform a unit check for the parking brake switch. Refer to WCS-41, "Component Inspection".
Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-69, "Removal and Installation" NO >> Replace parking brake switch. Refer to PB-4, "Exploded View".
The light reminder warning does not sound
Description Light reminder warning chime does not sound even though headlamp is illuminated. Diagnosis Procedure 1.CHECK COMBINATION SWITCH (LIGHTING SWITCH) OPERATION Check that the headlamps o ...Other materials:
Ecu diagnosis information
BCM (body control module)
Reference Value
VALUES ON THE DIAGNOSIS TOOL
TERMINAL LAYOUT
PHYSICAL VALUES
NOTE:
• *1: Without automatic A/C
• *2: RHD models
• *3: With manual A/C
• *4: LHD models
Fail-safe
FAIL-SAFE CONTROL BY DTC
BCM performs fail-safe contr ...
B1137 side air bag module LH
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp statu ...
IGN off interlock door unlock function does not operate
Diagnosis Procedure
1.CHECK “AUTOMATIC LOCK/UNLOCK SELECT” SETTING IN “WORK SUPPORT”
1. Select “DOOR LOCK” of “BCM” using CONSULT-III.
2. Select “AUTOMATIC LOCK/UNLOCK SELECT” in “WORK SUPPORT” mode.
3. Check “AUTOMATIC LOCK/UNLOCK SELECT” in “WORK SUPPORT”.
Refer to DLK-501, "DOOR LOCK ...