Nissan Juke Service and Repair Manual : The oil pressure warning lamp does not turn on

Description

The oil pressure warning lamp stays off when the ignition switch is turned ON.

Diagnosis Procedure

1.CHECK OIL PRESSURE WARNING LAMP

Perform auto active test. Refer to PCS-12, "Diagnosis Description" (with I-KEY) or PCS-43, "Diagnosis Description" (without I-KEY).

Is oil pressure warning lamp blinking? YES >> GO TO 2.

NO >> GO TO 4.

2.CHECK OIL PRESSURE SWITCH SIGNAL CIRCUIT

Check the oil pressure switch signal circuit. Refer to MWI-56, "Diagnosis Procedure".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair harness or connector.

3.CHECK OIL PRESSURE SWITCH

Perform a unit check for the oil pressure switch. Refer to MWI-56, "Component Inspection".

Is the inspection result normal? YES >> Replace IPDM E/R. Refer to PCS-34, "Removal and Installation" (with I-KEY) or PCS-63, "Removal and Installation" (without I-KEY).

NO >> Replace oil pressure switch. Refer to EM-330, "Disassembly and Assembly" (K9K).

4.CHECK COMBINATION METER INPUT SIGNAL

Connect CONSULT-III and perform an input signal check for the combination meter. Refer to MWI-56, "Component Function Check".

Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-69, "Removal and Installation".

NO >> Replace IPDM E/R. Refer to PCS-34, "Removal and Installation" (with I-KEY) or PCS-63, "Removal and Installation" (without I-KEY).

    The fuel gauge indicator does not operate
    Description Fuel gauge will not indicate from a certain position. Diagnosis Procedure 1.CHECK COMBINATION METER OUTPUT SIGNAL 1. Connect CONSULT-III. 2. Select the “Data Monitor” for the “METER/M ...

    The oil pressure warning lamp does not turn off
    Description The oil pressure warning lamp remains illuminated while the engine is running (normal oil pressure). Diagnosis Procedure 1.CHECK OIL PRESSURE WARNING LAMP Perform auto active test. R ...

    Other materials:

    Front fog lamp circuit
    Component Function Check 1.CHECK FRONT FOG LAMP OPERATION CONSULT-III ACTIVE TEST 1. Select “EXTERNAL LAMPS” of IPDM E/R active test item. 2. With operating the test items, check that the front fog lamp is turned ON. Fog : Front fog lamp ON Off : Front fog lamp OFF Is the measurement normal? ...

    C1166, C1167 SV system
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CONSULT ...

    P0643 sensor power supply
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. TESTING CONDITION: Before performing the following proced ...