Nissan Juke Service and Repair Manual : The oil pressure warning lamp does not turn off
Description
The oil pressure warning lamp remains illuminated while the engine is running (normal oil pressure).
Diagnosis Procedure
1.CHECK OIL PRESSURE WARNING LAMP
Perform auto active test. Refer to PCS-12, "Diagnosis Description" (with I-KEY) or PCS-43, "Diagnosis Description" (without I-KEY).
Is oil pressure warning lamp blinking? YES >> GO TO 2.
NO >> GO TO 5.
2.CHECK IPDM E/R OUTPUT VOLTAGE
1. Turn ignition switch OFF.
2. Disconnect the oil pressure switch connector.
3. Turn ignition switch ON.
4. Check voltage between the oil pressure switch harness connector and ground.
Is the inspection result normal? YES >> GO TO 3.
NO >> GO TO 4.
3.CHECK OIL PRESSURE SWITCH
Perform a unit check for the oil pressure switch. Refer to MWI-56, "Component Inspection".
Is the inspection result normal? YES >> Replace IPDM E/R. Refer to PCS-34, "Removal and Installation" (with I-KEY) or PCS-63, "Removal and Installation" (without I-KEY).
NO >> Replace oil pressure switch. Refer to EM-330, "Disassembly and Assembly" (K9K).
4.CHECK OIL PRESSURE SWITCH SIGNAL CIRCUIT
Check the oil pressure switch signal circuit. Refer to MWI-56, "Diagnosis Procedure".
Is the inspection result normal? YES >> GO TO 5.
NO >> Repair harness or connector.
5.CHECK COMBINATION METER INPUT SIGNAL
Connect CONSULT-III and perform an input signal check for the combination meter. Refer to MWI-56, "Component Function Check".
Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-69, "Removal and Installation".
NO >> Replace IPDM E/R. Refer to PCS-34, "Removal and Installation" (with I-KEY) or PCS-63, "Removal and Installation" (without I-KEY).
The oil pressure warning lamp does not turn on
Description The oil pressure warning lamp stays off when the ignition switch is turned ON. Diagnosis Procedure 1.CHECK OIL PRESSURE WARNING LAMP Perform auto active test. Refer to PCS-12, " ...The ambient temperature display is incorrect
Description • The displayed ambient air temperature is higher than the actual temperature. • The displayed ambient air temperature is lower than the actual temperature. Diagnosis Procedure NOTE: ...Other materials:
Engine stand setting
Setting
NOTE:
Explained here is how to disassemble with engine stand supporting transaxle
surface. When using different
type of engine stand, note with difference in steps and etc.
1. Remove the engine and the transaxle assembly from the vehicle, and separate
the transaxle from the
engine ...
On board diagnostic (OBD) system
Diagnosis Description
DESCRIPTION
The CVT system has two self-diagnostic systems.
The first is the emission-related on board diagnostic system (OBD) performed by
the TCM in combination with
the ECM. The malfunction is indicated by the MIL (malfunction indicator lamp)
and is stored as a DTC ...
Front fender
Exploded View
1. Front fender assembly
2. Front fender stiffener
: Vehicle front
Removal and Installation
REMOVAL
1. Remove front fillet molding. Refer to EXT-26, "FRONT FILLET MOLDING :
Removal and Installation".
2. Remove front bumper fascia assembly. Refer to EXT-13, "R ...