Nissan Juke Service and Repair Manual : The light reminder warning does not sound

Description

Light reminder warning chime does not sound even though headlamp is illuminated.

Diagnosis Procedure

1.CHECK COMBINATION SWITCH (LIGHTING SWITCH) OPERATION

Check that the headlamps operate normally by operating the combination switch (lighting switch).

Do they operate normally? YES >> GO TO 2.

NO >> Refer to EXL-75, "WITH DAYTIME RUNNING LIGHT SYSTEM : Symptom Table" (with daytime running light system) or EXL-74, "WITHOUT DAYTIME RUNNING LIGHT SYSTEM : Symptom Table" (without daytime running light system).

2.CHECK DRIVER SIDE DOOR SWITCH SIGNAL CIRCUIT

Perform the check for the driver side door switch signal circuit. Refer to DLK-87, "Diagnosis Procedure" (Type 1), DLK-258, "Diagnosis Procedure" (Type 2), DLK-397, "Diagnosis Procedure" (Type 3), or DLK-522, "Diagnosis Procedure" (Type 4).

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair harness or connector.

3.CHECK DRIVER SIDE DOOR SWITCH

Perform a unit check for the driver side door switch. Refer to DLK-88, "Component Inspection" (Type 1), DLK- 259, "Component Inspection" (Type 2), DLK-398, "Component Inspection" (Type 3), or DLK-523, "Component Inspection" (Type 4).

Is the inspection result normal? YES >> Replace BCM. Refer to BCS-93, "Removal and Installation" (with intelligent key system) or BCS- 161, "Removal and Installation" (without intelligent key system).

NO >> Replace driver side door switch. Refer to DLK-187, "Removal and Installation" (Type 1), DLK-350, "Removal and Installation" (Type 2), DLK-485, "Removal and Installation" (Type 3), or DLK-601, "Removal and Installation" (Type 4).

NOTE

:
To identify vehicle type, refer to DLK-17, "Information".

    The parking brake release warning continues sounding, or does not sound
    Description • The parking brake warning buzzer sounds continuously during vehicle travel though the parking brake is released. • The parking brake warning buzzer does not sound at all even though ...

    The seat belt reminder warning continues sounding, or does not sound
    Description • Seat belt reminder warning does not sound. • Seat belt reminder warning sounds continuously. Diagnosis Procedure 1.CHECK SEAT BELT WARNING LAMP 1. Turn ignition switch ON. 2. Check ...

    Other materials:

    Idle air volume learning
    Description Idle Air Volume Learning is a function of ECM to learn the idle air volume that keeps each engine idle speed within the specific range. It must be performed under any of the following conditions: • Each time electric throttle control actuator or ECM is replaced. • Idle speed or i ...

    Service
    • Disconnect battery negative terminal in advance. • Disconnect air bag system line in advance. • Never tamper with or force air bag lid open, as this may adversely affect air bag performance. • Be careful not to scratch pad and other parts. • When removing or disassembling any part, be care ...

    Back door opener switch
    Component Function Check 1.CHECK FUNCTION 1. Select “TRUNK” of “BCM” using CONSULT-III. 2. Select “TRNK OPNR SW” in “DATA MONITOR” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> Back door opener switch ...