Nissan Juke Service and Repair Manual : The key warning does not sound (without intelligent key)

Nissan Juke Service and Repair Manual / Warning Chime System / Symptom diagnosis / The key warning does not sound (without intelligent key)

Description

The key warning chime does not sound, when all of the following conditions are fulfilled.

• Key inserted into the key cylinder (key switch signal ON).

• Ignition switch is in ACC or OFF (ignition switch signal OFF).

• Driver side door is open (driver side door switch ON)

Diagnosis Procedure

1.CHECK BCM INPUT SIGNAL

1. Connect CONSULT-III.

2. Select the “Data Monitor” of “BCM (BUZZER)” and check the “KEY ON SW” monitor value. Refer to WCS- 21, "BUZZER : CONSULT-III Function (BCM - BUZZER)".

Is the inspection result normal? YES >> Replace BCM. Refer to BCS-161, "Removal and Installation".

NO >> GO TO 2.

2.CHECK KEY SWITCH SIGNAL CIRCUIT

Check the key switch signal circuit. Refer to DLK-401, "Diagnosis Procedure" (Type 3) or DLK-526, "Diagnosis Procedure" (Type 4).

Is the inspection result normal? YES >> Replace BCM. Refer to BCS-161, "Removal and Installation".

NO >> Check applicable parts, and repair or replace corresponding parts.

NOTE

:
To identify vehicle type, refer to DLK-357, "Information".

    The seat belt reminder warning continues sounding, or does not sound
    Description • Seat belt reminder warning does not sound. • Seat belt reminder warning sounds continuously. Diagnosis Procedure 1.CHECK SEAT BELT WARNING LAMP 1. Turn ignition switch ON. 2. Check ...

    Other materials:

    B1051, B1056 driver air bag module
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...

    Thermostat
    Exploded View 1. Thermostat housing 2. Gasket 3. Rubber ring 4. Thermostat 5. Water inlet 6. Clamp 7. Radiator hose (upper) A. To radiator Engine front : N·m (kg-m, ft-lb) : Always replace after every disassembly. Removal and Installation REMOVAL 1. Drain engine coolant from ...

    Combination switch input circuit
    Diagnosis Procedure 1.CHECK INPUT 1 - 5 CIRCUIT FOR OPEN 1. Turn ignition switch OFF. 2. Disconnect BCM and combination switch connectors. 3. Check continuity between BCM harness connector and combination switch harness connector. Does continuity exist? YES >> GO TO 2. NO >> ...