Nissan Juke Service and Repair Manual : The braking distance is long
Description
Brake stopping distance is long when ABS function is operated.
Diagnosis Procedure
CAUTION:
Brake stopping distance on slippery road like rough road, gravel road or snowy
road may become
longer when ABS is operated than when ABS is not operated.
1.CHECK BRAKING FORCE
Check brake force using a brake tester.
Is the inspection result normal? YES >> GO TO 2.
NO >> Check each components of brake system.
2.CHECK BRAKE PERFORMANCE
Disconnect ABS actuator and electric unit (control unit) connector so that ABS does not operate. Check brake stopping distance in this condition. Connect harness connectors after checking.
Is the inspection result normal? YES >> Normal
NO >> Check each components of brake system
Unexpected brake pedal reaction
Description A malfunction of brake pedal feel (height or others) is detected when brake pedal is depressed. Diagnosis Procedure 1.CHECK FRONT AND REAR AXLE Check that there is no excessive loose ...Does not operate
Description ESP function, TCS function, ABS function, EBD function and brake limited slip differential (BLSD) function does not operate. Diagnosis Procedure CAUTION: • ESP function, TCS functio ...Other materials:
G sensor calibration
Description
TCM stores calibration data (inherent characteristic value) of G sensor to
provide accurate control. Therefore,
it is required to perform calibration of G sensor after the following work is
performed.
• Removal/installation or replacement of G sensor
• Replacement of TCM
Proce ...
Evaporative emission system
Evaporative emission system: System
Diagram
Evaporative emission system : System
Description
INPUT/OUTPUT SIGNAL CHART
*: ECM determines the start signal status by the signals of engine speed and
battery voltage.
SYSTEM DESCRIPTION
The evaporative emission system is used to reduce hy ...
Idle speed
Description
This describes how to check the idle speed. For the actual procedure, follow
the instructions in “BASIC
INSPECTION”.
Special Repair Requirement
1.CHECK IDLE SPEED
With CONSULT-III
Check idle speed in “DATA MONITOR” mode with CONSULT-III.
With GST
Check idle speed with Servic ...