Nissan Juke Service and Repair Manual : The ambient temperature display is incorrect
Description
• The displayed ambient air temperature is higher than the actual temperature.
• The displayed ambient air temperature is lower than the actual temperature.
Diagnosis Procedure
NOTE
:
Check that the symptom is not applicable to the normal operating condition
before starting diagnosis. Refer to
MWI-68, "INFORMATION DISPLAY : Description".
1.CHECK AMBIENT SENSOR SIGNAL CIRCUIT
Check the ambient sensor signal circuit. Refer to HAC-56, "Diagnosis Procedure" (4WD models) or HAC-146, "Diagnosis Procedure" (2WD models).
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair harness or connector.
2.CHECK A/C AUTO AMP./PTC HEATER CONTROL UNIT CONNECTION
RECOGNITION SIGNAL CIRCUIT
Check the A/C auto amp./PTC heater control unit connection recognition signal circuit. Refer to MWI-62, "Diagnosis Procedure" (A/C auto amp.) or MWI-63, "Diagnosis Procedure" (PTC heater control unit).
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair harness or connector.
3.CHECK AMBIENT SENSOR
Perform the part check for the ambient sensor. Refer to HAC-57, "Component Inspection" (4WD models) or HAC-147, "Component Inspection" (2WD models).
Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-69, "Removal and Installation".
NO >> Replace ambient sensor. Refer to HAC-92, "Removal and Installation" (4WD models) or HAC- 189, "Removal and Installation" (2WD models).
The oil pressure warning lamp does not turn off
Description The oil pressure warning lamp remains illuminated while the engine is running (normal oil pressure). Diagnosis Procedure 1.CHECK OIL PRESSURE WARNING LAMP Perform auto active test. R ...Normal operating condition
INFORMATION DISPLAY INFORMATION DISPLAY : Description AMBIENT TEMPERATURE The displayed ambient temperature on the information display may differ from the actual temperature because it is a corr ...Other materials:
P17B8 high clutch solenoid
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition
switch OFF and wait for at
least 10 seconds, then perform the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
1. S ...
Door lock actuator
Driver side : Component Function Check
1.CHECK FUNCTION
1. Select “DOOR LOCK” of “BCM” using CONSULT-III.
2. Select “DOOR LOCK” in “ACTIVE TEST” mode.
3. Check that the function operates normally according to the following
conditions.
Is the inspection result normal?
YES >> Door lock ...
P183D side G sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.DTC REPRODUCTION PROCEDURE
With ...