Nissan Juke Service and Repair Manual : TCM

Exploded View

1. Bracket


1. Bracket 2. TCM

: N·m (kg-m, in-lb):Vehicle front
Removal and Installation: N·m (kg-m, in-lb)


Removal and Installation

CAUTION:
When replacing TCM, note the “CVTF DETERIORATION DATE” value displayed on CONSULT-III “CONFORM CVTF DETERIORTN” in MAINTENANCE BOOKLET, before start the operation.

NOTE:

When replacing TCM and transaxle assembly as a set, replace transaxle assembly first and then replace TCM. Refer to TM-374, "Description".

REMOVAL

1. Remove the battery. Refer to PG-124, "Removal and Installation".

2. Remove the air cleaner case. Refer to EM-161, "Removal and Installation".

3. Disconnect the TCM connector.

4. Remove the TCM.

5. Remove the bracket.

INSTALLATION

Installation is the reverse order of removal.

Adjustment

ADJUSTMENT AFTER INSTALLATION

Perform "ADDITIONAL SERVICE WHEN REPLACING TCM". Refer to TM-374, "Description

    Key interlock cable
    Exploded View 1. CVT shift selector assembly 2. Key interlock cable A: Key cylinder B: Clip C: Clip Removal and Installation REMOVAL CAUTION: Always apply the parking brake before perfor ...

    Air breather hose
    Removal and Installation REMOVAL 1. Remove clip from bracket. 2. Remove air breather hose from transaxle assembly. INSTALLATION Note the following, and install in the reverse order of removal. ...

    Other materials:

    BCM branch line circuit
    Diagnosis Procedure 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the BCM for damage, bend and loose connection (unit side and connector side). Is the inspection result normal? YES &g ...

    Diagnosis system (BCM) (with intelligent key system)
    Description Air conditioning system performs self-diagnosis, operation check, function diagnosis, and various settings using diagnosis function of each control unit. Common item : consult-III Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT-III performs the following functions via CAN ...

    Throttle valve closed position learning
    Description Throttle Valve Closed Position Learning is an operation to learn the fully closed position of the throttle valve by monitoring the throttle position sensor output signal. It must be performed each time harness connector of electric throttle control actuator or ECM is disconnected. ...