Nissan Juke Service and Repair Manual : Take away warning does not operate

Diagnosis Procedure

1.CHECK DTC WITH BCM AND COMBINATION METER

Check that DTC is not detected with BCM and combination meter.

Is the inspection result normal? YES >> GO TO 2.

NO-1 >> Refer to BCS-67, "DTC Index". (BCM) NO-2 >> Refer to MWI-36, "DTC Index". (Combination meter)

2.CHECK COMBINATION METER BUZZER

Check combination meter buzzer.

Refer to WCS-40, "Component Function Check".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace the malfunctioning parts.

3.CHECK KEY WARNING LAMP

Check key warning lamp.

Refer to DLK-94, "Component Function Check".

Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace the malfunctioning parts.

4.CHECK DOOR SWITCH

Check door switch.

Refer to DLK-87, "Component Function Check".

Is the inspection result normal? YES >> GO TO 5.

NO >> Repair or replace the malfunctioning parts.

5.CHECK INTELLIGENT KEY WARNING BUZZER

Check Intelligent Key warning buzzer.

Refer to DLK-92, "Component Function Check".

Is the inspection result normal? YES >> GO TO 6.

NO >> Repair or replace the malfunctioning parts.

6.CHECK INSIDE KEY ANTENNA

Check inside key antenna.

• Instrument center: Refer to DLK-55, "DTC Logic".

• Console: Refer to DLK-57, "DTC Logic".

• Luggage room: Refer to DLK-59, "DTC Logic".

Is the inspection result normal? YES >> GO TO 7.

NO >> Repair or replace the malfunctioning parts.

7.REPLACE BCM

1. Replace BCM. Refer to BCS-93, "Removal and Installation".

2. Confirm the operation after replacement.

Is the result normal? YES >> INSPECTION END

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    ACC warning does not operate
    Diagnosis Procedure 1.CHECK COMBINATION METER BUZZER Check combination meter buzzer. Refer to WCS-40, "Component Function Check". Is the inspection result normal? YES >> GO TO ...

    Intelligent key low battery warning does not operate
    Diagnosis Procedure 1.CHECK DTC WITH BCM AND COMBINATION METER Check that DTC is not detected with BCM and combination meter. Is the inspection result normal? YES >> GO TO 2. NO-1 >& ...

    Other materials:

    No or very little acceleration, increase in engine speed
    Description CHART 8: NO OR VERY LITTLE ACCELERATION, INCREASE IN ENGINE SPEED Diagnosis Procedure 1.CHECK FUEL Check that the fuel reservoir is correctly filled and with the right fuel. >> GO TO 2. 2.CHECK ECM POWER SUPPLY AND GROUND CIRCUIT Check ECM power supply and ground circuit ...

    Door cable
    Exploded View LEFT SIDE 1. Heater unit assembly 2. Intake door lever 3. Intake door link 4. Intake door cable 5. Air mix door cable 6. Air mix door link 7. Air mix door rod 8. Lower air mix door lever 9. Upper air mix door lever 10. Max. cool door A. To A/C control RIGHT SIDE ...

    Service Notice or Precautions for EPS System
    • Check the following item when performing the trouble diagnosis. - Check any possible causes by interviewing the symptom and it′s condition from the customer if any malfunction, such as EPS warning lamp is turned ON, occurs. - Check if air pressure and size of tires are proper, the spe ...