Nissan Juke Service and Repair Manual : System initialization
Description
If any of the following operations are performed, the initialization is necessary for normal operation of power window system.
• Disconnection and connection of battery cable from negative terminal.
• When power window main switch replaced.
• Electric power supply to power window main switch or power window motor (driver side) is interrupted by blown fuse or disconnection and connection of the negative terminal of battery, etc.
• Disconnection and connection of power window main switch harness connector.
• Removal of power window motor (driver side) from regulator assembly.
• Operation of regulator assembly as an independent unit.
• Removal and installation of glass.
• Removal and installation of door glass run.
CAUTION:
The following specified operations can not be performed under the
non-initialized condition.
• Auto-up operation
• Anti-pinch function
Work Procedure
1.STEP 1
1. Turn ignition switch ON.
2. Operate power window switch to fully open the window. (This operation is
unnecessary if the window is
already fully open)
3. Continue pulling the power window switch UP (AUTO-UP operation). Even after
glass stops at fully closed
position, keep pulling the switch for 2 seconds or more.
4. Check that AUTO-UP function operates normally.
>> GO TO 2.
2.STEP 2
Check anti-pinch function. Refer to PWC-17, "Work Procedure".
>> END
Additional service when replacing control unit
Description When the control unit replaced, the initialization in necessary for normal operation of power window system. CAUTION: The following specified operations can not be performed under t ...Check anti-pinch function
Description If any of the following operations are performed, the initialization is necessary for normal operation of antipinch function. • Disconnection and connection of battery cable from ne ...Other materials:
Not communication with the ECM
Description
CHART 1: NO COMMUNICATION WITH THE ECM
Diagnosis Procedure
1.INSPECTION START
Ensure that CONSULT-III is not causing the malfunction by trying to establish
dialogue with an ECM on
another vehicle. If the CONSULT-III is not at malfunction, and dialogue cannot
be established with ...
P0544 EGT sensor 1
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.CHECK GROUND CONNECTIONS
1. Turn ignition switch OFF.
2. Check ground connection E38. Refer to Ground inspection in GI-44, "Circuit
Inspection".
Is the inspection result normal?
YES >> GO TO 2.
NO >> Repair or ...
Cup holders
CAUTION
• Avoid abrupt starting and braking when the cup holder is being used
to prevent spilling the drink. If the liquid is hot, it can scald you or your passenger.
• Use only soft cups in the cup holder.
Hard objects can injure you in an accident.
Center console
Door (front and r ...